Skip to Content

Changes for page Front I/O

Last modified by Kevin Wiki on 2024/07/07 22:48
From version 3.1
edited by Kevin Wiki
on 2024/07/04 22:57
Change comment: There is no comment for this version
To version 3.2
edited by Kevin Wiki
on 2024/07/04 23:00
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -6,19 +6,9 @@
6 6  
7 7  There is a single cable that controls four parts, each half side of I/O LED and center column of blue LEDs.
8 8  
9 -== Sub-paragraph ==
9 +== ==
10 10  
11 -Lorem ipsum dolor sit amet, consectetur adipiscing elit, sed do eiusmod tempor incididunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco laboris nisi ut aliquip ex ea commodo consequat. Duis aute irure dolor in reprehenderit in voluptate velit esse cillum dolore eu fugiat nulla pariatur. Excepteur sint occaecat cupidatat non proident, sunt in culpa qui officia deserunt mollit anim id est laborum.
12 12  
13 -== Sub-paragraph ==
14 -
15 -Lorem ipsum dolor sit amet, consectetur adipiscing elit, sed do eiusmod tempor incididunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco laboris nisi ut aliquip ex ea commodo consequat. Duis aute irure dolor in reprehenderit in voluptate velit esse cillum dolore eu fugiat nulla pariatur. Excepteur sint occaecat cupidatat non proident, sunt in culpa qui officia deserunt mollit anim id est laborum.
16 -
17 -=== Sub-sub paragraph ===
18 -
19 -Lorem ipsum dolor sit amet, consectetur adipiscing elit, sed do eiusmod tempor incididunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco laboris nisi ut aliquip ex ea commodo consequat. Duis aute irure dolor in reprehenderit in voluptate velit esse cillum dolore eu fugiat nulla pariatur. Excepteur sint occaecat cupidatat non proident, sunt in culpa qui officia deserunt mollit anim id est laborum.
20 -
21 -
22 22  = How we got here =
23 23  
24 24  Measure out the ground and power signals by comparing with other chips on board. E.g. we find [SAA1064T] datasheet, locate the GND (Vee) and 5V (Vcc) and measure connectivity (0 ohm resistance) between chip pins and cable pins. This gives us pins GND 2 & 8 and PWR 16 & 22.